Water Demister Manufacturer for Air Purification

The structural design and installation of demister pad is featured of the combination of units and integrated connection of each level to ensure that the eliminator does not fall off as a whole or partly. the operating environment occurs instantaneous, over-temperature or blade scaling, clogging, leading overload

Demister efficiency: ≥90-99%
Demister body pressure drop ≥ 35pa, less than or equal to 150pa (clean state)
Critical flow rate: 3.5-5.0 m / s

Flue gas separates droplets away under the action of inertia force and gravity when passing bending channel of the Mist Eliminator. Then desulfurized flue gas flows through mist eliminator in a certain speed and changes running direction quickly and continuously. Droplets in the flue gas are captured while crashing into mist eliminator blades under the action of centrifugal force and inertial force. They gather and form into a stream and then drop back to the slurry pool under gravity. Finally gas and liquid are separated, and the flue gas which flows through the demister is discharged after meeting the standard of mist removal. Demisting efficiency of mist eliminator increases as the air velocity gets higher. 

The plate type demister pad is crossly made by corrugated shape blade and steel plate. It is installed on top of tower and perpendicular to structure of flue gas. There are two layers of design: first and second level. Flue gas imports into mist layer vertically. Steel plate and the blade are connected with hotgas welding and thermofussion welding.